Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » how to make a wiring harness of the side mirrors
Viewing all articles
Browse latest Browse all 10

2005 Honda Civic Hybrid Fog Light Installation – Page 1

0
0

2005 Honda Civic Hybrid Fog Light Installation

1. Ensure you have the anti-theft code for the radio, then write down the radio station presets.
2. Open the hood and disconnect the adverse cable from the battery.

Fog Light Installation : Cutting the Front Bumper

fog light3. Remove these components from the entrance bumper: 4 prime clips, six backside clips, two backside self- tapping screws, and two fender space screws. Take away the entrance bumper by pulling it out toward you. Place the entrance bumper on a blanket, to stop harm whereas installing the fog lights.
4. Apply masking tape across the cover on the left side of the entrance bumper as shown.
5. Sporting gloves, remove the cover from the left aspect of the entrance bumper by cutting the five tabs with a hand saw.
6. Using a file, end the edges smooth and flat, and take away the masking tape.
7. Contained in the bumper, make a gap within the middle mark on the bumper with a pushpin.
8. Whereas wearing eye protection, drill an eight mm gap via the outlet you just made. First drill with a 3mm drill bit, then with a 6 mm drill bit, and finish with an 8 mm drill bit. Take away any burrs from the edge of the hole.
9. Repeat steps four thru 8 to chop and drill the fitting aspect of the bumper.

Routing the Fog Light Harness

10. Disconnect the optimistic (+) battery cable. Take away the positive battery cable, and clip from the battery.
11. Take away the battery holder bolt and nut, then take away the battery holder.
12. Remove the battery.
13. Take away the ability steering reserve tank from the car bracket by pulling it upward. Move the reserve tank out of the way.
14. Route the fog light harness 2-pin connector (long aspect) through the square hole underneath the rear of the suitable headlight up and into the engine compartment.
15. On the vehicle frame, remove the ground terminal bolt, then attach the fog lights harness floor terminal using the bottom terminal bolt. Don’t connect with the centralized floor on the front side.
16. Secure the fog lights harness to the car harness close to the sq. gap in the entrance fender with one wire tie.
17. Route the fog light harness to the left alongside the car harness. Secure it to the car harness with the four wire ties within the areas shown.
18. Continue to route the fog light harness to the left (driver’s) facet alongside the car harness and up through the opening underneath the left headlight.
19. Secure the fog light harness to the car harness with six wire ties.
20. On the precise (passenger’s) facet of the vehicle, secure the fog light harness to the vehicle harness with one wire tie.
21. Attach two wire ties with clips to the fog gentle harness, then push the clips into the holes in the fitting front side plate.
22. Secure the fog light harness, routed to the decrease aspect of the left headlight, to the vehicle harness with three wire ties in the areas shown. Don’t safe to the fog light harness to the yellow SRS harness.

Page 1 | Page 2


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images